
XX112-36-00 Rev 909 Kollector Hybrid Network Digital Video Recorder Configuring the ViconNet System • 131
7. Enter the macro commands. The commands available for matrix macros are Pause and Matrix.
• Pause: In the case where several matrix commands are configured, Pause enables you to set the
amount of time the first command will run before the second matrix command takes over.
Example
In one matrix command, only four cameras can be configured. If you want more than four cameras
to be displayed on the analog outputs, you can configure the matrix macro so that every X minutes
another four cameras are displayed. To do this, you must configure several matrix commands, each
time with four other cameras, but between the matrix commands, you set pause commands with a
duration of X minutes.
NOTE: In a macro with only one matrix command (up to four cameras), there is no need for a
pause command because once the matrix macro is running, the cameras will be displayed
on the analog monitors until the macro is stopped manually.
• Matrix: Displays the site list (bottom left) and four output dropdown boxes (monitors). From the
output boxes, select which camera goes to which output.
To define which camera display connects to which output, click Matrix.
Select the camera to be displayed on each analog output from the dropdown boxes in the
bottom panel and click Apply.
To define the duration of the recording click Pause.
To set other cameras to connect to the four analog outputs after the pause, repeat steps 7.1 to
7.3.
8. To apply the changes, click Apply.
9. To save the changes, click Save.
The matrix macro can be run manually from here, or scheduled from the scheduler (see section Creating
Schedules, page 156.
NOTE: The Matrix macro is also referred to as the Switcher macro.
Komentáře k této Příručce