Vicon CE202D-N Instalační příručka stáhnout pdf (Strana 67)

3.8 Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup>System> Maintenance

web page (described in “3.5.5 System > Maintenance”) or use the Reset button on the network

camera, as described below.

• Using the Reset Button

Follow the instructions below to reset the network camera to the factory default settings using

the Reset button.

1. Power off the network camera by disconnecting the power adapter.

2. Remove camera cover if not already done so.

3. Press and hold the Reset button with a straightened paperclip while reconnecting the power.

4. Keep the Reset button pressed during about 2 seconds.

5. Release the Reset button.

6. The network camera resets to factory defaults and restarts after completing the factory

reset.

7. Reattach the camera cover.

Caution: When performing a Factory Reset, you will lose any settings you have saved.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 73 74

Žádné komentáře

Vicon CE202D-N Instalační příručka Strana 67