Vicon VDR-408 Uživatelský manuál stáhnout pdf (Strana 5)

4 | Virtual Matrix Display Controller Connection and Setup Guide

Connections

Connect the cable from the monitor to the appropriate connector on the

display card(s) on the rear panel of the VMDC; only 2 monitor connections

can be used from each card; choose from the VGA, DVI or HDMI connectors.

Be sure to make connections from the leftmost card first before moving to the

next card, as noted in the Figure above. A DVI to VGA converter is provided

in the accessory kit, if needed. Connect the keyboard and mouse to their

respective USB connectors.

Additionally, 1 USB to serial port connector is supplied for serial-based PLC

devices only; this is not for use with the System Controller.

Windows will number the monitors according to their priority. Windows setup

follows.

VGA Monitor 15-pin

Connector(s)

DVI Monitor Connector(s)

RJ-45 Connector for Network

HDMI Monitor Connector(s)

USB Connector

9-pin Serial

Connector

1 2 3 4 5 6 7 8 9 10 11

Žádné komentáře

Vicon VDR-408 Uživatelský manuál Strana 5